On a Pi,
sudo apt install nvme-cli
Then run as above but with sudo and I get this on a sabrent device. Sorry, I don't have PI NVME drive handy.
sudo apt install nvme-cli
Then run as above but with sudo and I get this on a sabrent device. Sorry, I don't have PI NVME drive handy.
Code:
$ sudo nvme id-ctrl -H /dev/nvme0NVME Identify Controller:vid : 0x1987ssvid : 0x1987sn : 2A140715157300284885mn : Sabrent Rocket nano fr : RKT301.3rab : 1ieee : 6479a7cmic : 0 [3:3] : 0ANA not supported [2:2] : 0PCI [1:1] : 0Single Controller [0:0] : 0Single Portmdts : 6cntlid : 0x1ver : 0x10300rtd3r : 0x124f80rtd3e : 0x2191c0oaes : 0 [31:31] : 0Discovery Log Change Notice Not Supported [27:27] : 0Zone Descriptor Changed Notices Not Supported [15:15] : 0Normal NSS Shutdown Event Not Supported [14:14] : 0Endurance Group Event Aggregate Log Page Change Notice Not Supported [13:13] : 0LBA Status Information Notices Not Supported [12:12] : 0Predictable Latency Event Aggregate Log Change Notices Not Supported [11:11] : 0Asymmetric Namespace Access Change Notices Not Supported [9:9] : 0Firmware Activation Notices Not Supported [8:8] : 0Namespace Attribute Changed Event Not Supportedctratt : 0 [19:19] : 0Flexible Data Placement Not Supported [15:15] : 0Extended LBA Formats Not Supported [14:14] : 0Delete NVM Set Not Supported [13:13] : 0Delete Endurance Group Not Supported [12:12] : 0Variable Capacity Management Not Supported [11:11] : 0Fixed Capacity Management Not Supported [10:10] : 0Multi Domain Subsystem Not Supported [9:9] : 0UUID List Not Supported [8:8] : 0SQ Associations Not Supported [7:7] : 0Namespace Granularity Not Supported [6:6] : 0Traffic Based Keep Alive Not Supported [5:5] : 0Predictable Latency Mode Not Supported [4:4] : 0Endurance Groups Not Supported [3:3] : 0Read Recovery Levels Not Supported [2:2] : 0NVM Sets Not Supported [1:1] : 0Non-Operational Power State Permissive Not Supported [0:0] : 0128-bit Host Identifier Not Supportedrrls : 0cntrltype : 0 [7:2] : 0Reserved [1:0] : 0Controller type not reportedfguid : 00000000-0000-0000-0000-000000000000crdt1 : 0crdt2 : 0crdt3 : 0nvmsr : 0 [1:1] : 0NVM subsystem Not part of an Enclosure [0:0] : 0NVM subsystem Not part of an Storage Devicevwci : 0 [7:7] : 0VPD Write Cycles Remaining field is Not valid. [6:0] : 0VPD Write Cycles Remaining mec : 0 [1:1] : 0NVM subsystem Not contains a Management Endpoint on a PCIe port [0:0] : 0NVM subsystem Not contains a Management Endpoint on an SMBus/I2C portoacs : 0x17 [10:10] : 0Lockdown Command and Feature Not Supported [9:9] : 0Get LBA Status Capability Not Supported [8:8] : 0Doorbell Buffer Config Not Supported [7:7] : 0Virtualization Management Not Supported [6:6] : 0NVMe-MI Send and Receive Not Supported [5:5] : 0Directives Not Supported [4:4] : 0x1Device Self-test Supported [3:3] : 0NS Management and Attachment Not Supported [2:2] : 0x1FW Commit and Download Supported [1:1] : 0x1Format NVM Supported [0:0] : 0x1Security Send and Receive Supportedacl : 0aerl : 3frmw : 0x12 [5:5] : 0Multiple FW or Boot Update Detection Not Supported [4:4] : 0x1Firmware Activate Without Reset Supported [3:1] : 0x1Number of Firmware Slots [0:0] : 0Firmware Slot 1 Read/Writelpa : 0xe [6:6] : 0Telemetry Log Data Area 4 Not Supported [5:5] : 0LID 0x0, Scope of each command in LID 0x5, 0x12, 0x13 Not Supported [4:4] : 0Persistent Event log Not Supported [3:3] : 0x1Telemetry host/controller initiated log page Supported [2:2] : 0x1Extended data for Get Log Page Supported [1:1] : 0x1Command Effects Log Page Supported [0:0] : 0SMART/Health Log Page per NS Not Supportedelpe : 15 [7:0] : 15 (0's based)Error Log Page Entries (ELPE)npss : 4 [7:0] : 4 (0's based)Number of Power States Support (NPSS)avscc : 0x1 [0:0] : 0x1Admin Vendor Specific Commands uses NVMe Formatapsta : 0x1 [0:0] : 0x1Autonomous Power State Transitions Supportedwctemp : 358 [15:0] : 85°C (358 Kelvin)Warning Composite Temperature Threshold (WCTEMP)cctemp : 368 [15:0] : 95°C (368 Kelvin)Critical Composite Temperature Threshold (CCTEMP)mtfa : 100hmpre : 139672hmmin : 546tnvmcap : 512,110,190,592[127:0] : 512,110,190,592Total NVM Capacity (TNVMCAP)unvmcap : 0[127:0] : 0Unallocated NVM Capacity (UNVMCAP)rpmbs : 0 [31:24]: 0Access Size [23:16]: 0Total Size [5:3] : 0Authentication Method [2:0] : 0Number of RPMB Unitsedstt : 30dsto : 1fwug : 4kas : 1hctma : 0x1 [0:0] : 0x1Host Controlled Thermal Management Supportedmntmt : 273 [15:0] : 0°C (273 Kelvin)Minimum Thermal Management Temperature (MNTMT)mxtmt : 358 [15:0] : 85°C (358 Kelvin)Maximum Thermal Management Temperature (MXTMT)sanicap : 0x6 [31:30] : 0Additional media modification after sanitize operation completes successfully is not defined [29:29] : 0No-Deallocate After Sanitize bit in Sanitize command Supported [2:2] : 0x1Overwrite Sanitize Operation Supported [1:1] : 0x1Block Erase Sanitize Operation Supported [0:0] : 0Crypto Erase Sanitize Operation Not Supportedhmminds : 0hmmaxd : 0nsetidmax : 0endgidmax : 0anatt : 0anacap : 0 [7:7] : 0Non-zero group ID Not Supported [6:6] : 0Group ID does change [4:4] : 0ANA Change state Not Supported [3:3] : 0ANA Persistent Loss state Not Supported [2:2] : 0ANA Inaccessible state Not Supported [1:1] : 0ANA Non-optimized state Not Supported [0:0] : 0ANA Optimized state Not Supportedanagrpmax : 0nanagrpid : 0pels : 0domainid : 0megcap : 0sqes : 0x66 [7:4] : 0x6Max SQ Entry Size (64) [3:0] : 0x6Min SQ Entry Size (64)cqes : 0x44 [7:4] : 0x4Max CQ Entry Size (16) [3:0] : 0x4Min CQ Entry Size (16)maxcmd : 0nn : 1oncs : 0x5e [8:8] : 0Copy Not Supported [7:7] : 0Verify Not Supported [6:6] : 0x1Timestamp Supported [5:5] : 0Reservations Not Supported [4:4] : 0x1Save and Select Supported [3:3] : 0x1Write Zeroes Supported [2:2] : 0x1Data Set Management Supported [1:1] : 0x1Write Uncorrectable Supported [0:0] : 0Compare Not Supportedfuses : 0 [0:0] : 0Fused Compare and Write Not Supportedfna : 0x1 [3:3] : 0Format NVM Broadcast NSID (FFFFFFFFh) Supported [2:2] : 0Crypto Erase Not Supported as part of Secure Erase [1:1] : 0Crypto Erase Applies to Single Namespace(s) [0:0] : 0x1Format Applies to All Namespace(s)vwc : 0x1 [2:1] : 0Support for the NSID field set to FFFFFFFFh is not indicated [0:0] : 0x1Volatile Write Cache Presentawun : 255awupf : 0icsvscc : 1 [0:0] : 0x1NVM Vendor Specific Commands uses NVMe Formatnwpc : 0 [2:2] : 0Permanent Write Protect Not Supported [1:1] : 0Write Protect Until Power Supply Not Supported [0:0] : 0No Write Protect and Write Protect Namespace Not Supportedacwu : 0ocfs : 0 [1:1] : 0Controller Copy Format 1h Not Supported [0:0] : 0Controller Copy Format 0h Not Supportedsgls : 0 [15:8] : 0SGL Descriptor Threshold [1:0] : 0Scatter-Gather Lists Not Supportedmnan : 0maxdna : 0maxcna : 0subnqn : ioccsz : 0iorcsz : 0icdoff : 0fcatt : 0 [0:0] : 0Dynamic Controller Modelmsdbd : 0ofcs : 0 [0:0] : 0Disconnect command Not Supportedps 0 : mp:4.50W operational enlat:0 exlat:0 rrt:0 rrl:0 rwt:0 rwl:0 idle_power:- active_power:- active_power_workload:-ps 1 : mp:2.70W operational enlat:0 exlat:0 rrt:1 rrl:1 rwt:1 rwl:1 idle_power:- active_power:- active_power_workload:-ps 2 : mp:2.16W operational enlat:0 exlat:0 rrt:2 rrl:2 rwt:2 rwl:2 idle_power:- active_power:- active_power_workload:-ps 3 : mp:0.0700W non-operational enlat:1000 exlat:1000 rrt:3 rrl:3 rwt:3 rwl:3 idle_power:- active_power:- active_power_workload:-ps 4 : mp:0.0020W non-operational enlat:5000 exlat:45000 rrt:4 rrl:4 rwt:4 rwl:4 idle_power:- active_power:- active_power_workload:-
Statistics: Posted by jamesh — Fri Jan 24, 2025 4:51 pm