HATs and other add-ons • Lorawan Gateway Gateway Offline in ChirpStack Web UI...
I have configured a ChirpStack LoRaWAN setup using a Raspberry Pi 4 and a Seeed WM1302 gateway module. Initially, the LoRaWAN packets were successfully received and verified in the ChirpStack Web...
View ArticleHATs and other add-ons • Mounting PICAN FD (with LIN-bus attachment) on Rpi5
Hello!Im doing a project where I want to mount a PiCAN FD on top of a Raspberry Pi 5.I am sort of a newbie in regards to the electronics but wonder what type of headers/pins I would need to connect to...
View ArticleHATs and other add-ons • Re: Mounting PICAN FD (with LIN-bus attachment) on Rpi5
i.e. https://shop.pimoroni.com/products/2x20 ... 1132812269Statistics: Posted by aBUGSworstnightmare — Tue Mar 25, 2025 1:05 pm
View ArticleHATs and other add-ons • w5500 module not working with RBPI5, but ok with RBPI4
After several retry, come to conclusion is that it is the RBPI device alone that makes the difference. My setup:Brand new, unmodified installation of Rb Pi OS (64-bit) by RPi Imager (the issue is same...
View ArticleHATs and other add-ons • Waveshare SPI touch display with headless pi?
I have a Waveshare 3.5 inch capacative touch IPS display (https://www.amazon.ca/dp/B0DNQJD7BV) that I want to use with a Pi (probably Pi Zero) on headless mode. Does anyone hsve experience setting...
View ArticleHATs and other add-ons • Re: Waveshare SPI touch display with headless pi?
Display so not "headless"Search the forum for kiosk, regarding your display ask waveshare support if you have problems connecting it.Statistics: Posted by wildfire — Thu Mar 27, 2025 4:37 pm
View ArticleHATs and other add-ons • Re: Pi4 TV-HAT continuity errors when ARM clock...
There has been a lot of trouble with the TV-HAT since I switched from Pi3B+ to Pi4B. Until about 24 hours ago when I decided to stop using networked rootfs and went back to SD-card and also doing an...
View ArticleHATs and other add-ons • Kvaser USB not creating can0 interface on Raspberry...
I’m trying to set up a Kvaser USB-to-CAN adapter on a Raspberry Pi to read CAN data. I installed the Kvaser linuxcan drivers, and the device is detected in lsusb, but ip link set can0 up type can...
View ArticleHATs and other add-ons • Re: Case for a Raspberry Pi5 with m2 Hat with 2.5...
Anyone have an M2 Hat with the 2.5gb Network Adapter?Statistics: Posted by PiHat — Sat Mar 29, 2025 3:23 pm
View ArticleHATs and other add-ons • Re: Build HAT-enabled SLAM robot?
I have done something that achieves similar goals but in a different way.You can find the main repo for my project at https://github.com/gregorianrants/composed-robotSome things you should know:There...
View ArticleHATs and other add-ons • Which cases for RPI 5 are completely silent and...
Hello, I plan to use it in a silent room. Any good suggestions?Statistics: Posted by raspberry_user — Sun Mar 30, 2025 9:48 pm
View ArticleHATs and other add-ons • Re: Which cases for RPI 5 are completely silent and...
The Pi 5 bumper?https://www.raspberrypi.com/products/bumper/I'd recommend adding heatsinks too.Statistics: Posted by wildfire — Sun Mar 30, 2025 10:08 pm
View ArticleHATs and other add-ons • Re: PoE HAT causing Network Failures - Common Problem?
I'm having the same exact issue. I have a feeling that its introducing some serious signal noise to the network. I've had the PoE hat for a while, finally had a project i need it for, and its...
View ArticleHATs and other add-ons • Re: 52pi N16 Quad NVME Board [EP-0180] & GeeekPi...
@rmasseyJust a quick update. GeekPi did kindly send me another board to test in the end. The replacement N16 board i received is the revision shipped with the flexible USB-C ribbon type power cable...
View ArticleHATs and other add-ons • Official m.2 Hat - Does it Use the GPIO Pins
Does the Raspberry Pi m.2 Hat use any of the GPIO pins for power or data? I know that it has a header that attaches to the pins, but I'm wondering if that's just for stability. There are other m.2...
View ArticleHATs and other add-ons • ASIX Electronics Corp. AX88179 Gigabit Ethernet
I gut this usb to ethernet adapator which seems to work (or seemed to work for a couple of weeks) but now generates lots of TCP retransimissions. I believe because it is in half duplex:Code: $ ethtool...
View ArticleHATs and other add-ons • Re: Official m.2 Hat - Does it Use the GPIO Pins
Welcome new user!A forum search would have brought the answer: no. No GPIO - apart from the I2C interface which is also not used but connected - is in use.Statistics: Posted by aBUGSworstnightmare —...
View ArticleHATs and other add-ons • After latest updates, HATs report "Humidity...
On all 5 of my RPIs (3 3B+, a 4 and a 5) Python calls to get_temperature (get_temperature_from_humidity) and get_humidity fail with:OSError: Humidity Init FailedThis happened after I did my weekly...
View ArticleHATs and other add-ons • Re: (Ancient) Raspberry Pi Zero?
At https://meshtastic.org/docs/hardware/de ... aspberrypi it lists the Zero as supported.Their site says "Raspberry Pi: Zero 2, 3, 4, Pi 400, and Pi 5 on Raspbian bookworm." Unlcear if that means...
View ArticleHATs and other add-ons • Re: After latest updates, Sense HATs report...
I can confirm the same.4 Pi with Sense HAT (I guess those are v1, no light sensors), are also failing getting humidity sensor value, with new kernel 6.12.20Statistics: Posted by rcoll — Tue Apr 01,...
View Article